Selleys Liquid Nails Heavy Duty 350g

Selleys Liquid Nails Heavy Duty 350gSelleys Liquid Nails Heavy Duty is an advanced high performance construction adhesive which means mechanical fasteners can be removed after 8 hours*. The non slump formulation also offers extreme strength and durability, even when bonding two non-porous materials. It can be used on most building substrates.Features2 times more strength than Liquid Nails in less than half the time*Fast speed of cure means mechanical fasteners can be removed after 8 hours on porous surfaces, compared to 24 hours for Liquid NailsNo drip, slump or stringing, even when applying a bead to overhead surfacesExcellent resistance to water and weather makes it suitable for interior and exterior applicationsStrong bond that is flexible enough to respond to building movementEasy to extrude from the cartridge at low winter temperaturesWhere can this product be used?Sheet flooring to joistsMetal or aluminium door strips to floors and wallsTimber or fibre cement sheeting to cement block or brick wallsMasonite/hardboard to timber or floorboardsWallboard or panelling to wood or metal framesCork tiles to timber, fibre cement or plasterTimber flooring to yellow tongue in conjunction with mechanical fixings to avoid later squeakingWhat materials is this product suitable for?TimberMDFPlasterboardPlastics** (pre-test to determine suitability)MasonryConcreteParticleboardMetalsRubberGlassTilesCeramics**Not for polyethylene, polypropylene or Teflon.How to use?Do not swallow. Use in a well ventilated area. Avoid contact with skin and eyes. Pierce foil seal before inserting into caulking gun.Ensure surfaces are dry and free from oil, grease and dust. Wipe off any pooled water from wet timber.Cut cartridge tip and pierce foil, attach nozzle and cut to size (5mm), then insert into caulking gun.Apply bead along length of joist, stud or batten. On broad flat surfaces apply beads every 40cm.Position pieces and press firmly together. Fix with sufficient nails, screws or clamping to hold load and achieve contact over total bond area. Repositionable for up to 20 minutes after fitting.Allow adhesive to set (minimum 8 hours) before removing any temporary fasteners or clamping. Use with mechanical fasteners in high stress applications.Contact Bond Method:For immediate bond use contact bond method, apply to one surface only, press together and pull apart. Allow surfaces to dry 2-4 minutes, before firmly joining.For Flooring:When fixing sheet flooring (eg. particle board), use in conjunction with flooring manufacturers installation specifications for minimum nailing requirements.Note: To eliminate squeaks in tongue and groove flooring, use Liquid Nails Heavy Duty in conjunction with mechanical fixings.Limitations:Avoid use in tightly clamped joints eg. cabinet making or joinery.Not for use on mirrors. Use Liquid Nails Mirror Aluminium.Not for metals heated by direct sunlight. Bonds weaken at higher temperatures.Not for Styrene foam. Use Liquid Nails Fast Grab.Do not use as the sole bonding agent for structural bonding.Not for permanent water immersion.**Pre-test plastics to determine compatibility. Not for polyethylene, polypropylene or Teflon.